Post Event Image Buffer

dbw · Post by **dbw** » Mon Jan 30, 2006 12:52 am

hey everyone,

im currently using ZM v1.21.3 on FC3, but im having trouble getting the Post Event Image Buffer to work effectively. From what i understand this is the amount of frames that will be recorded after the motion stops. So as my cam (dlink dcs-900) is running at 15 fps, i set this to 450 which should record an extra 30 seconds of footage? however i am not getting anything more than the few seconds which contained motion.

any help would be appreciated,

jared.

Post by **zoneminder** » Mon Jan 30, 2006 11:23 am

Have you tried it with a range of smaller values first to check that it is being saved correctly and behaving itself?