Post Event Image Buffer
Posted: Mon Jan 30, 2006 12:52 am
hey everyone,
im currently using ZM v1.21.3 on FC3, but im having trouble getting the Post Event Image Buffer to work effectively. From what i understand this is the amount of frames that will be recorded after the motion stops. So as my cam (dlink dcs-900) is running at 15 fps, i set this to 450 which should record an extra 30 seconds of footage? however i am not getting anything more than the few seconds which contained motion.
any help would be appreciated,
jared.
im currently using ZM v1.21.3 on FC3, but im having trouble getting the Post Event Image Buffer to work effectively. From what i understand this is the amount of frames that will be recorded after the motion stops. So as my cam (dlink dcs-900) is running at 15 fps, i set this to 450 which should record an extra 30 seconds of footage? however i am not getting anything more than the few seconds which contained motion.
any help would be appreciated,
jared.