quit alarm status

marcel · Post by **marcel** » Tue Jul 18, 2006 1:30 pm

I installed Zoneminder on a debian sarge system.
All seems working.
many thanks to all who made the documentation.

I defined a small zone at the edge of my first camera image.
and then i put the monitor in alarm (moving something inside the zone)
the monitor goes in 'alarm state' and Zoneminder begins to save images in event directory.
My question:
How do I quit alarm status? How is it possible to return to normal status x minutes after an event?
I think I don't understand something may be because my bad english..
best regards

marcel

jameswilson · Post by **jameswilson** » Tue Jul 18, 2006 1:46 pm

Unless your settings are wrong the monitor should return to normal after the alarm has passed plus post alarm image count. If would think that you have your zone set a bit to sensitive

dyuen · Post by **dyuen** » Tue Jul 18, 2006 5:17 pm

marcel,
Did you set anything on Linked monitors in montor configuration? If so, delete them and try again.

marcel · Post by **marcel** » Wed Jul 19, 2006 11:56 am

thank you james, dyuen
for your answers!

I deleted what I put into linked monitors,
now it works.