ZoneMinder Forums

Hi there,

I have experience a strange problem. When I setup the ZoneMinder 1.2.2, my card works without problem. however, when I update to ZoneMinder 1.2.3; compile without problem; when i login to ZM, all I see is the grey box (the monitor) without image;

I have double check the card (install in M$-win XP), it works..

The following is the dmesg

System
AMD XP2000 CPU
2.6.18 kernel.
Fedora 5

-----

saa7130[0]: found at 0000:02:00.0, rev: 1, irq: 18, latency: 32, mmio: 0xec000000
saa7134: <rant>
saa7134: Congratulations! Your TV card vendor saved a few
saa7134: cents for a eeprom, thus your pci board has no
saa7134: subsystem ID and I can't identify it automatically
saa7134: </rant>
saa7134: I feel better now. Ok, here are the good news:
saa7134: You can use the card=<nr> insmod option to specify

Are there in errors in the logs?
What did you do when you upgraded?

Regards,
Corey

I did not do anything, expect the ZM upgrade from 1.2.2 to 1.2.3 .. i really have no idea what went wrong;

cordel wrote:Are there in errors in the logs?
What did you do when you upgraded?

Regards,
Corey

Okay so what steps did you take to do the upgrade?
If you don't elaborate, I don't know what you might have did wrong ether.

Regards,
Corey

OK, here is what I did

I use Ubuntu 5.05 and install the ZM with my SAA7134 card. it works.

After I run the apt-get update/upgrade stuff. the system seems have some problem.

I install the new system using ubuntu 6.0 and install ZM 1.2.3, after that it does not work any more; i even try to down-grade to ZM 1.2.2 ..and did not have any luck. I try everything I know but ..end up writing this post ..

cordel wrote:Okay so what steps did you take to do the upgrade?
If you don't elaborate, I don't know what you might have did wrong ether.

Regards,
Corey

there would appear something in 5.05 that worked with teh bttv driver that isnt there in 6