Entering pan speed in hex?
Posted: Wed Jan 10, 2007 12:44 pm
I was wondering if you can enter pan/tilt ranges in hex eg:
my pan speed is 0x00 full speed
0x80 no speed
I entered these above values in the control script entry fields but they were set back to "0" on opening it a second time?
Other range values are C0, A7, etc.....
my pan speed is 0x00 full speed
0x80 no speed
I entered these above values in the control script entry fields but they were set back to "0" on opening it a second time?
Other range values are C0, A7, etc.....