Page 1 of 1
Two monitors from one shared memory (one zmc and two zma)
Posted: Sun May 20, 2007 11:35 am
by hrabe
Is it possible implement sharing video for all types of source (IP camera,...) - run more then one zma for the same zmc...
Thanks for your response.
Posted: Mon May 21, 2007 11:38 am
by zoneminder
No that is currently not possible, though you can have more than one monitor using the same source, either IP camera or analog.
Posted: Mon May 21, 2007 1:44 pm
by hrabe
It is not possible to use IP cameras more than ones because of bandwidth (WiFi NET, big ressolution, frame-rate)
Posted: Mon May 21, 2007 10:07 pm
by jameswilson
As i have said in your other thread mate, create a monitor using the zm box as a source for the 2nd monitor, that way you get 2 monitors and only 1 over the ip link
Posted: Tue May 22, 2007 6:39 am
by hrabe
And what about https problem?
Posted: Tue May 22, 2007 6:04 pm
by cordel
hrabe wrote:And what about https problem?
What problem????
Posted: Tue May 22, 2007 8:25 pm
by hrabe
With https I have no picture from source url (Yes, I use port 443). And with this solution pictures are very bad because there are to many transformations - jpg from camera to bmp (1. st capture), bmp to jpg (next stream), jpg to bmp (2.nd capture), analyze, bmp to jpg (save) - brrrrr
And cpu load....
Posted: Tue May 22, 2007 9:01 pm
by cordel
You must have Apache configured incorrectly then or didn't setup a cert. HTTPS works fine.
As for your other issue I have no idea.
Posted: Tue May 22, 2007 9:29 pm
by hrabe
https works OK on console, monitors, events view... But does not work as remote source in monitor (for me).
Posted: Wed May 23, 2007 1:43 am
by jameswilson
why use https on an internal link anyway, just use
http://127.0.0.1 or localhost
Posted: Wed May 23, 2007 7:03 am
by hrabe
Yes, I use loopback for all local comunications.